loading
reading
writing
saving
searching
NEW Hayes Dominion T4 (F) T2 (R) Carbon lever Mountain Bike brakeset - $249 (South Mountain)
QR Code Link to This Post
These brakes have an MSRP of $800 plus tax for complete set of these lightweight heavyweights. I am a systems tester, and have the same brakes on my bike if you would like to test them. I have them NEW for $275ea side for the T2-T4 combination.
The trimmed version of the well regarded Hayes Dominion A-series. The performance of the T-series is identical to the A-series since the hydraulics are identical, only the titanium and carbon fiber elements make them a whole lot lighter.
I have learned that the best brakes for me are the ones that have the fewest things to not like about them. Good brakes transparently and consistently do the same thing every time we use them (out of mind), it is only when they scare us do we take notice. Here is a list that shows how these brakes in the top 5 industry wide, and top 2 for me. I have used no less than 10-12 different brake technologies in the last 20 years, and 20-30 different brake pads.
So why are these special?
1. The big one, light touch. Reduced hand fatigue and arm pump. The ball bearing lever pivot, light return spring and teflon glide ring master piston makes these handles the easiest to actuate, less than 4 oz finger force to bite point. Most brakes, like Code RSC, are closer to 20oz, or worse, over 2 lb for the Maven. That is just to make pad contact, before any actual braking. Hayes light touch is a characteristic of these brakes that the user will never be conscious of UNTIL you try brakes that are not designed for true single finger freedom. All force goes into braking, not overcoming inefficiency. The result is less hand, finger and arm fatigue.
2. CARBON FIBER brake lever shaped by Reynolds an ergonomic improvement over most designs. Bare handed riders never experience a cold lever.
3. Titanium hardware.
4. Highly machined for lowest total weight, 253g for T2 handle hose and caliper.
5. K2 Brake hose is well known as the stiffest, especially important for the rear brake with longer run to avoid squishy lever feel due to ballooning.
6. Highest hydraulic leverage, 20% higher than shimano.
7. The surface area of the T4 brake pad is 24% greater than 4-piston shimano. The T2 pad has only 7% less area than shimano 4-piston. The T2 directly compares to 4-piston power, but with improved feel.
8. Modulation best described as aggressively linear, unlike Sram, which are either binary (rsc) or unaggressive (r)
9. No moving bite point.
10. Ratings show lowest maintenance, highest reliability, in class.
11. The only brakes with crosshair caliper alignment screws, which adds sanity to the task of pad-rotor spacing.
12. Highest power to weight ratio among all braking systems, except trickstuff.
13. 2 caliper bleed ports, easier to remove a caliper bubble.
14. Can be gravity bled using a shimano funnel.
15. T2 pads are TOP LOADING. This is a huge convenience, no removing the wheel to adjust or replace pads.
Ask for T4 front, T2 rear for better braking balance. The T2 has about 10% less power, where less power means more control of rear traction.
Most people will be more than happy with T2 Front and Rear, or for a more balanced and more powerful T4 front only with T2 rear. This will provide the best proportioned (balanced) enduro-oriented brakeset, since the front tire provides 2-3 times the traction and braking of the rear tire during hard braking. This is also how motorcycles and cars are designed. Putting a T4 on the rear is just overkill for most cases and loss of traction control is often the result. Whatever your preference, these brakes are best for any lightweight build where peak performance and modulation meets the least fatigue.
NEW IN BOX set for just $250 each side, or $499 total, $300 less than the bike shop. Want 4-piston on the rear also? Add $75.
I-10 and Chandler Blvd
See the "more ads by this user" link above for more bike parts